A440F, A442F, A443E

This bush is supplied with no warranty and is fitted by the discretion of the purchaser!

The Original Bush is fitted with an interference fit and as per most OE bushings it is oversized and then milled to size in a centralising Jig, this allows for any defects in the casting of the pump and centralises the torque convertor.

Many reason may cause the failure of this bush including, incorrect fitment of convertor and a tight spigot, wich inturn can cause runout. refer to OE manual for tightening convetor bolts, it is suggetsed that you work the bolts in going from the first to next at 180 degrees and so on till the convertor is seated in the spigot and tighten to OE specs.

Be sure that all dowels are fitted and convertor is installed into pump correctly.